 |
The patent pending Klir Drop-In Automatic Fleece Filter Di-7 V2 fits directly into most four-inch filter sock chambers that automatically unroll new material as it gets clogged, removing suspended particles from an aquarium and producing crystal clear water. The easy-to-mount, magnetic water sensor detects when the fleece is dirty and automatically advances a new clean section, offering months of maintenance-free
filtration. For sumps without filter socks you can use the Klir Drop In Automatic Fleece Filter 7" Filter Bracket.
The Klir Filter is a direct replacement for filter socks on sumps with
sock trays. Simply remove the filter sock from the sump and insert the
Klir. As water passes through the Klir filter and the filtering
material becomes saturated with waste, the water level will begin to
rise. When the water makes contact with the optical sensor, a motor is
activated to advance clean filtering material. As clean material is
exposed, water can then flow freely, lowering the water level in the
sock tray and deactivating the motor.
For sumps without filter socks you can use the Klir Drop-In Automatic Fleece Filter Di-7 V2 Bracket.
Klir's Filtration Main Benefits:
- Easy drop-in installation, no plumbing required. No additional sump space is needed.
-
Results in crystal clear water filtered down to 50-microns — double the filtering capacity of most filter socks.
- Waste is removed from the water column before it has time to break down, helping to maintain low nutrient parameters!
- The constant chore of monitoring and swapping filter socks or other mechanical media every few days is eliminated for months at a time.* Once the filtering media is exhausted, replacing it is a snap and very economical.
*Life of fleece depends on many variables, including (but not limited to): biological load, feeding habits, and flow rate.
Klir Di-7 V2 Includes:
- Klir 7" Drop-In Automatic Fleece Filter
- 6.9" Swappable Collar
- 7.55" Swappable Collar
- V2 Smart Controller & Magnet-mount Sensor
- 50-Yard Roll of 50-Micron Fleece
- Activated Carbon Insert
- DC Geared Motor (DC12V/.6A)
Sump Requirements:
- A) Sump with sock tray (or use the Klir Filter Bracket [sold separately])
- B) Capable of holding at least 1.5 inches of water above the sock tray
- C) 8.125 inches of available space below the filter sock tray
- D) 7.125-inch sump lid opening directly above the filter socks
|
|
|
